Skip to main content
18 December, 2021
Laser scanned data provides reliable and consistently accurate set of assets to design and engineer high quality products. Most non-professional 3D scanning options offer lower precision and tolerances, which may affect product fitment and quality control.
5 January, 2017
We were tasked to perform a full 3D laser scan of the Subaru EJ25 engine block for research and development purposes. Both halves of the engine block were scanned from all directions, allowing us to capture all the intricate details inside and out.
6 December, 2016
For this project we were asked to perform a laser scan of the lower center console of the 2015 Subaru WRX and STI. The resolution of the scan was detailed enough to capture the textured surfaces of the OEM dashboard. Areas that were not needed were masked off in tape.
22 November, 2016
For this project we were asked to perform a laser scan of the center console area on the upper dashboard of the 2008-2011 Subaru Imrpeza WRX. The resolution of the scan was detailed enough to capture the textured surfaces of the OEM dashboard. Areas that were not needed (i.e.
18 October, 2016
In order to design aftermarket components with OEM-like fitment, we captured a full exterior scan of the 2012-2016 Subaru BRZ at high accuracy. This data is later used for product development and design prototyping.
6 October, 2016
In order to design new interior accessory products to fit perfectly into the Scion FR-S, highly accurate measurements of the surfaces, geometry, and mechanical asembly (snap fit clips, mounting points) are required.
1 October, 2016
For this project we were tasked to perform a full scan of the Subaru WRX race car. The highly accurate scanned data can later be used for product development (new designs), archiving-purposes, or analysis (CFD, FEA, etc.).
6 September, 2016
This project was to laser scan the interior dashboard center console area of the 2002-2007 Subaru Impreza. The data was later used for product development purposes, specifically to design new, replacement plastic trim pieces.
16 July, 2016
This project's objective was to scan the entire Scion FR-S (also known as the Toyota GT86 outside of North America); sibling to the Subaru BRZ. We scanned both versions (FR-S and BRZ), and data is used for the development of custom-designed exterior accessories (aftermarket bodykits).
Subscribe to Subaru